Any one that is replacing the passenger rear fender or has a routed out body. I am in need of part of the feneder top. I am repairing the area where a roll bar was installed and need a patch panel. I will post a picture next week of the size and area I need.
Message me if you have something
Thansk
Rear fender pease needed
Moderators: rickf, raymond, Mr. Recovery
-
Txjeeper81
- Sergeant
- Posts: 69
- Joined: April 6th, 2016, 9:28 am
Rear fender pease needed
CSM In the Texas State Guard
National United States Armed Forces Museum
1943 MB W/Trailer "Puddle Jumper II"
1968 m274A5 "Little S.N.A.F.U"
1976 M151a2 "Kermit"
National United States Armed Forces Museum
1943 MB W/Trailer "Puddle Jumper II"
1968 m274A5 "Little S.N.A.F.U"
1976 M151a2 "Kermit"
Re: Rear fender pease needed
Are you aware that CMD has replacement fender tops?
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
-
Txjeeper81
- Sergeant
- Posts: 69
- Joined: April 6th, 2016, 9:28 am
Re: Rear fender pease needed
Yes I am but I only need a pease that's about 7x9 inchs not the whole panel.
Last edited by Txjeeper81 on December 23rd, 2016, 12:07 am, edited 2 times in total.
CSM In the Texas State Guard
National United States Armed Forces Museum
1943 MB W/Trailer "Puddle Jumper II"
1968 m274A5 "Little S.N.A.F.U"
1976 M151a2 "Kermit"
National United States Armed Forces Museum
1943 MB W/Trailer "Puddle Jumper II"
1968 m274A5 "Little S.N.A.F.U"
1976 M151a2 "Kermit"
Re: Rear fender pease needed
Gotcha.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone