Front Crossmember Mounting Hardware

[hondo100]

I've searched the 20P and 34P manuals and the forum with no luck.... Can anyone point me to where I can find the part numbers for the front crossmember mounting hardware?

Thanks

[Mr. Recovery]

TM 9-2320-218-34-1 talk's about and show's it in section 9-7 Front Suspension & Drive Assembly Removal & Installation but, they don't give the size or part numbers for the bolts, not sure where to find it other then someone having them out and able to measure them for you.

Dan.

[rickf]

Did you check the 34P?

[Mr. Recovery]

Did you check the 34P?

As for me, yes, he said he did in his post.

Dan.

[muttguru]

I've searched the 20P and 34P manuals and the forum with no luck.... Can anyone point me to where I can find the part numbers for the front crossmember mounting hardware? Thanks

Hondo, here's what I can tell you.
Bolt, Machine, p/no. 8754891 1/2". I've checked all my versions of the -34 and -34P but the actual length of these bolts is not stated. You are going to have to make an educated guess as to the length.
However, there's a bit more of a clue when it comes to the nut used. The description says: Nut, plain, hexagon, p/no. MS51968-15, 1/2"-20 UNF-2B.
So the bolt is 1/2" Diameter and the thread is as above. From this you should be able to obtain your hardware.
Hope this helps....
Ken

[fergrn37]

8754891

Name Value
THREAD CLASS 2A
THREAD DIRECTION RIGHT-HAND
FASTENER LENGTH 1.760 INCHES NOMINAL
HEAD STYLE HEXAGON
HEAD HEIGHT 0.364 INCHES MINIMUM AND 0.386 INCHES MAXIMUM
NOMINAL THREAD DIAMETER 0.500 INCHES
GRIP LENGTH 0.760 INCHES NOMINAL
FEATURES PROVIDED UNFINISHED HEAD
HARDNESS RATING 28.0 ROCKWELL C NOMINAL OVERALL
MATERIAL STEEL OVERALL

[hondo100]

Thanks to everyone for the information.