Distributor oil seal
Moderators: rickf, raymond, Mr. Recovery
Distributor oil seal
Anyone have a part # for the oil seal inside the distributor.
- svramselaar
- Major
- Posts: 1107
- Joined: December 30th, 2007, 6:48 am
- Location: holland
Re: Distributor oil seal
hi
i do net see a seal at the distributor
TM9-2320-218-34P
Figure 44. Distributor, Cables, and Spark Plug
TM 9-2320-218-34P
Figure 45. Distributor Assemble.
george
i do net see a seal at the distributor
TM9-2320-218-34P
Figure 44. Distributor, Cables, and Spark Plug
TM 9-2320-218-34P
Figure 45. Distributor Assemble.
george
Re: Distributor oil seal
Mine has an oil seal underneath the advance weights.
-
- Brigadier General
- Posts: 2495
- Joined: October 1st, 2010, 12:19 am
- Location: El Dorado, Arkansas
Re: Distributor oil seal
Which one??
Re: Distributor oil seal
# 33, getting oil through it into the distributor. Going to run to a bearing supply house to see if they can match it up, which I doubt. Hope someone has a replacement number or a seal. Thanks for the diagram Buddy
-
- Brigadier General
- Posts: 2495
- Joined: October 1st, 2010, 12:19 am
- Location: El Dorado, Arkansas
Re: Distributor oil seal
That is listed as a washer, part # 5307283, I don't think I have one without tearing down a distributor.
Re: Distributor oil seal
Is your PCV valve working? Is your fording valve in the open position if you have one? Sounds like too much crankcase pressure to me. Oil does not run straight uphill.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
Re: Distributor oil seal
PVC valve was taken apart ,was clean and working, vent lines are clear . Thought same thing. No fording valves. Had rear main leaking on a M-38 one time and it was a stuck PVC valve. Been there done all that.