transfer case

This is the place to get help with technical matters concerning your M151 jeep

Moderators: rickf, Mr. Recovery, raymond, moose53

Re: transfer case

Sponsor

Sponsor
 

Re: transfer case

Postby rickf » May 7th, 2018, 6:56 am

If you have a deep socket or a piece of pipe that fits the outer diameter of the seal so you can drive against it while sliding over the shaft then that is the way to go since the shaft will help to center the seal. Otherwise you can install the seal first and put some grease on the shaft and be careful when you insert the shaft so you do not roll the edge of the seal.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
rickf
General
General
 
10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership
 
Posts: 15372
Joined: November 26th, 2007, 12:28 pm
Location: Pemberton, NJ.

Re: transfer case

Postby incoming » May 7th, 2018, 8:35 pm

Sounds great Rick. Thanks for the reply sir!
incoming
Sergeant
Sergeant
 
2 years of membership2 years of membership
 
Posts: 75
Joined: September 12th, 2016, 9:13 pm
Location: West Monroe, LA

Previous

Return to Technical Discussion

Who is online

Users browsing this forum: No registered users and 2 guests

Customization by G838.org