coils

This is the place to get help with technical matters concerning your M151 jeep

Moderators: rickf, Mr. Recovery, raymond, moose53

coils

Sponsor

Sponsor
 

coils

Postby Lindsay36551 » June 6th, 2018, 4:55 pm

Hey guys, I was going thru some old stock parts today.
What should the ohm reading be for a coil?
All old take out units.
I've got a couple that are reading 7.5 and 3 that rate at 10.5
Thanks
Lindsay
1967 M-35-a2-D SOLD
1973 M151A2
M151 A1-SOLD
196? franken MUTT
M1oo trailer
1963 M151
1968 M416 trailer
Lindsay36551
2nd Lieutenant
2nd Lieutenant
 
6 years of membership6 years of membership6 years of membership6 years of membership6 years of membership6 years of membership
 
Posts: 837
Joined: December 19th, 2011, 11:31 am
Location: eustis fl

Re: coils

Postby Hambone » June 6th, 2018, 6:15 pm

This should get you there.
viewtopic.php?f=3&t=6222
Hambone
Colonel
Colonel
 
7 years of membership7 years of membership7 years of membership7 years of membership7 years of membership7 years of membership7 years of membership
 
Posts: 1431
Joined: September 30th, 2010, 11:19 pm
Location: El Dorado, Arkansas

Re: coils

Postby rickf » June 6th, 2018, 7:52 pm

The one thing that thread does not mention is that it is common to see 10-11.5 on the primary of the Chinese coils when they are good. Different number of windings and I am sure a different gauge of wire used for the windings. So if the 3 that are in the 10 range are shiny ones then they are probably good. At least as they sit, the problems will turn up when they heat up in use if they are bad. I have a couple of them here that test great but when you try to run them they will shut down in about 2 minutes.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
rickf
General
General
 
10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership
 
Posts: 15214
Joined: November 26th, 2007, 12:28 pm
Location: Pemberton, NJ.

Re: coils

Postby Lindsay36551 » June 8th, 2018, 3:49 pm

Thanks,
Rick these are all take out coils that I have(nice and dull finish) the good stuff.
1967 M-35-a2-D SOLD
1973 M151A2
M151 A1-SOLD
196? franken MUTT
M1oo trailer
1963 M151
1968 M416 trailer
Lindsay36551
2nd Lieutenant
2nd Lieutenant
 
6 years of membership6 years of membership6 years of membership6 years of membership6 years of membership6 years of membership
 
Posts: 837
Joined: December 19th, 2011, 11:31 am
Location: eustis fl


Return to Technical Discussion

Who is online

Users browsing this forum: Google [Bot], Google Adsense [Bot] and 4 guests

Customization by G838.org