Battery Distribution Upgrade Directions

This is the place to get help with technical matters concerning your M151 jeep

Moderators: rickf, Mr. Recovery, raymond, moose53

Battery Distribution Upgrade Directions

Sponsor

Sponsor
 

Battery Distribution Upgrade Directions

Postby m75 » August 29th, 2018, 1:50 pm

I'm picking back up on installing this upgrade, but if course the directions sheet is now missing. Can someone supply a copy?
Jim Peterson
SGM, 31B Retired 2015
1961 M151 -Sold
1974 M151A2, Working It!
m75
Sergeant First Class
Sergeant First Class
 
3 years of membership3 years of membership3 years of membership
 
Posts: 290
Joined: April 12th, 2015, 1:01 pm
Location: Antelope Valley, CA

Re: Battery Distribution Upgrade Directions

Postby Fil Bonica » August 29th, 2018, 9:33 pm

Find # 21 in the passenger rear harness.
Break open the connector.
Take the jumper and connect to each end.
The loose wire is then connected to the license plate light.
If you need the assembly I can supply an equivalent with a wire long enough to reach the license plate frame for $15.00 shipped.

Fil Bonica
K1ABW
Fil Bonica
Brigadier General
Brigadier General
 
10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership
 
Posts: 2457
Joined: December 9th, 2007, 9:49 am
Location: Falmouth, MA

Re: Battery Distribution Upgrade Directions

Postby m75 » August 30th, 2018, 8:55 am

Thanks Fil, but what I'm looking for is (properly) called Battery Junction Terminal Kit, part# 12302545. There is a printed schematic that comes with the kit. This schematic is what I'm hoping someone can send me a copy of.
Jim Peterson
SGM, 31B Retired 2015
1961 M151 -Sold
1974 M151A2, Working It!
m75
Sergeant First Class
Sergeant First Class
 
3 years of membership3 years of membership3 years of membership
 
Posts: 290
Joined: April 12th, 2015, 1:01 pm
Location: Antelope Valley, CA

Re: Battery Distribution Upgrade Directions

Postby Fil Bonica » August 30th, 2018, 9:31 am

Misunderstood :was relating to a prior post
Every time I used one of those kits I immediately threw the directions away when finished.
In fact the only parts that I used were the jumper and the big electrical stud that mounts between the two batteries.
I then reconnected the battery cable and the jumper.
Any accessory wiring can be added there.
Never used the rubber battery terminal boots and stiffeners because they were too awkward
Always liked the old style boots that surrounded the terminal.
Hope this helps and doesnt confuse the issue more.

Fil Bonica
K1ABW
Fil Bonica
Brigadier General
Brigadier General
 
10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership
 
Posts: 2457
Joined: December 9th, 2007, 9:49 am
Location: Falmouth, MA

Re: Battery Distribution Upgrade Directions

Postby Fil Bonica » August 30th, 2018, 8:14 pm

If you refer to the -20-1-1 pgs5-60.2 thru 5-65
Change 2
You will find some good info on how the parts are installed.
Its not the original instructions but it is a good alternate.

Fil Bonica
K1ABW
Fil Bonica
Brigadier General
Brigadier General
 
10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership10 years of membership
 
Posts: 2457
Joined: December 9th, 2007, 9:49 am
Location: Falmouth, MA

Re: Battery Distribution Upgrade Directions

Postby rstel01 » September 15th, 2018, 1:55 pm

Image

Hope this helps

ugh..I see it is resizing it and I made it a large file so you can read it.

try the link also

https://ibb.co/h0jpKz
rstel01
Private First Class
Private First Class
 
Posts: 20
Joined: May 11th, 2018, 9:00 am

Re: Battery Distribution Upgrade Directions

Postby m75 » September 16th, 2018, 12:28 pm

Thanks to all for the assist!
Jim Peterson
SGM, 31B Retired 2015
1961 M151 -Sold
1974 M151A2, Working It!
m75
Sergeant First Class
Sergeant First Class
 
3 years of membership3 years of membership3 years of membership
 
Posts: 290
Joined: April 12th, 2015, 1:01 pm
Location: Antelope Valley, CA


Return to Technical Discussion

Who is online

Users browsing this forum: No registered users and 3 guests

Customization by G838.org