LS-166/U Loud Speaker

Want to put radios in your jeep? Discuss it here.

Moderators: rickf, moose53, Mr. Recovery, raymond

LS-166/U Loud Speaker



LS-166/U Loud Speaker

Postby Jane » December 26th, 2016, 7:53 pm

Hi All,
I have a LS-166/U Loud Speaker, I want to use it with my RT442, but the speaker connector does not match. I understand this speaker came with a U-77/U connector and was later up-graded with a U-229 connector. With this up-grade will it then match the RT 442 ?
If this is correct, where can I find this type of connector.
Thank You.
4 years of membership4 years of membership4 years of membership4 years of membership
Posts: 28
Joined: December 19th, 2014, 9:15 pm

Re: LS-166/U Loud Speaker

Postby kmam » December 26th, 2016, 8:20 pm

You can get some info from

If you are up to it you could wire a plug to connect to the mount for the 442 but another solution is to get an LS-671 and the correct cable. You then have a speaker and can also plug a mic into the LS-671. Trouble is those cables are a bit difficult to find. Also, if pissible, get an LS-671 with the mounting plate and screws - again, a bit hard to find.

LS-671 info is at


Daimler Ferret Mk 1/2
AM General M151A2
RAAF Tactical Trailer
1st Sergeant
1st Sergeant
3 years of membership3 years of membership3 years of membership
Posts: 444
Joined: June 6th, 2015, 6:39 am
Location: Kuranda, Far North Queensland, Australia

Return to Communications

Who is online

Users browsing this forum: No registered users and 1 guest

Customization by