Antenna Ball???
Moderators: rickf, raymond, Mr. Recovery
-
- Master Sergeant
- Posts: 399
- Joined: March 9th, 2008, 8:05 pm
Antenna Ball???
Ok stupid question before I break it, how do you remove the ball off a antenna tip????
Jeff
Army Transportation Assoc Vietnam, Associate Member
Vietnam Veterans Assoc, Associate Member
Green Mountain Military Vehicle Club
1968 M52A2
1968 M54A2
1968 M151A1
1964 M151A1
1953 M62
1951 M37
" I am deuceless" Sold them all.
Army Transportation Assoc Vietnam, Associate Member
Vietnam Veterans Assoc, Associate Member
Green Mountain Military Vehicle Club
1968 M52A2
1968 M54A2
1968 M151A1
1964 M151A1
1953 M62
1951 M37
" I am deuceless" Sold them all.
- Jay Mallari
- 1st Lieutenant
- Posts: 931
- Joined: December 7th, 2007, 10:30 pm
- Location: Middlesex, England
Re: Antenna Ball???
I might be wrong but I think they only go in one way because the "teeth" inside the ball will dig in the antenna element if you try to pull it.
That way, it stays permanent so you'll probably have to break it to remove it.
Jay
That way, it stays permanent so you'll probably have to break it to remove it.
Jay
-
- Master Sergeant
- Posts: 399
- Joined: March 9th, 2008, 8:05 pm
Re: Antenna Ball???
that sucks................I think I have some new ones somewhere but I really want to put my antenna tie down on!!!! In vietnam, they did not have the handy clip to hold the antenna. Instead they used a .50 cal link and slid it down as far as it would go and tied the rope to the other loop.
Jeff
Army Transportation Assoc Vietnam, Associate Member
Vietnam Veterans Assoc, Associate Member
Green Mountain Military Vehicle Club
1968 M52A2
1968 M54A2
1968 M151A1
1964 M151A1
1953 M62
1951 M37
" I am deuceless" Sold them all.
Army Transportation Assoc Vietnam, Associate Member
Vietnam Veterans Assoc, Associate Member
Green Mountain Military Vehicle Club
1968 M52A2
1968 M54A2
1968 M151A1
1964 M151A1
1953 M62
1951 M37
" I am deuceless" Sold them all.
-
- Sergeant First Class
- Posts: 242
- Joined: December 8th, 2007, 11:29 am
- Location: Allentown, PA
Re: Antenna Ball???
Just remove all the tape and pull it off.