M416 Wiring Question
Moderators: rickf, raymond, Mr. Recovery
-
- Master Sergeant
- Posts: 399
- Joined: March 9th, 2008, 8:05 pm
M416 Wiring Question
Hey all, I took the wiring off and I cant remember if the wire runs up over between the frame and the tub at the front where it comes from the intervehicle cable or does it go under the frame and into the holes down the side. I would think it goes above the frame and scoot between the tub and the frame.
Jeff
Army Transportation Assoc Vietnam, Associate Member
Vietnam Veterans Assoc, Associate Member
Green Mountain Military Vehicle Club
1968 M52A2
1968 M54A2
1968 M151A1
1964 M151A1
1953 M62
1951 M37
" I am deuceless" Sold them all.
Army Transportation Assoc Vietnam, Associate Member
Vietnam Veterans Assoc, Associate Member
Green Mountain Military Vehicle Club
1968 M52A2
1968 M54A2
1968 M151A1
1964 M151A1
1953 M62
1951 M37
" I am deuceless" Sold them all.
- Mr. Recovery
- Brigadier General
- Posts: 2895
- Joined: December 5th, 2007, 9:03 pm
- Location: New Port Richey, Fl.
- Contact:
Re: M416 Wiring Question
Hope this helps!
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
-
- Master Sergeant
- Posts: 399
- Joined: March 9th, 2008, 8:05 pm
Re: M416 Wiring Question
LOL, nope not really!!! I cant see my area of concern. If you look as it goes foreward through the last horizontal support (in the flipped picture). It goes up the frame to the pintal, it then needs to go inside that frame. When it crosses that frame, is it between the frame and the tub???? I cant remember how mine was. If anyone has a M416, just take a peak and tell me. I might just remove the bolts from the tub again and sneak it between there as I would think that it would but I am not sure.
Jeff
Army Transportation Assoc Vietnam, Associate Member
Vietnam Veterans Assoc, Associate Member
Green Mountain Military Vehicle Club
1968 M52A2
1968 M54A2
1968 M151A1
1964 M151A1
1953 M62
1951 M37
" I am deuceless" Sold them all.
Army Transportation Assoc Vietnam, Associate Member
Vietnam Veterans Assoc, Associate Member
Green Mountain Military Vehicle Club
1968 M52A2
1968 M54A2
1968 M151A1
1964 M151A1
1953 M62
1951 M37
" I am deuceless" Sold them all.
Re: M416 Wiring Question
I know on mine the tub is tight against the frame all along the outer edges and also tight against the lip on the front. I would be pretty sure it goes under at that point. If you have to loosen a bolt to get it in then that is not the right route. The harness will come out without removing any bodywork.
Rick
Rick
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
- Mr. Recovery
- Brigadier General
- Posts: 2895
- Joined: December 5th, 2007, 9:03 pm
- Location: New Port Richey, Fl.
- Contact:
Re: M416 Wiring Question
The wires run up and over the frame just behind the parking brake .
http://s195.photobucket.com/albums/z96/ ... =001-6.jpg
http://s195.photobucket.com/albums/z96/ ... =001-6.jpg
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
Re: M416 Wiring Question
Not being on my own computer at the time, I can't really see the pictures in the detail needed to view the area in question, but I'm going to say UNDER. If I'm picturing the area in question properly, it is not impinged by the tub, and looks somewhat vulnerable, and under the frame at the front of the tub.
Rainman
Rainman
M151 World Land Speed Record Holder
- Mr. Recovery
- Brigadier General
- Posts: 2895
- Joined: December 5th, 2007, 9:03 pm
- Location: New Port Richey, Fl.
- Contact:
Re: M416 Wiring Question
I went out back into the "SWAMP" and uncovered two of the trailers to have a look, they both run under the drawbar then to the frame,
trailer#1
trailer#2
The page I posted earlier was from a trailer TM dated Oct. 1970, perhaps it was changed at a later date.
trailer#1
trailer#2
The page I posted earlier was from a trailer TM dated Oct. 1970, perhaps it was changed at a later date.
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
Re: M416 Wiring Question
Thanks Dan,
That's what I attempted to describe.
Sunman
That's what I attempted to describe.
Sunman
M151 World Land Speed Record Holder
Re: M416 Wiring Question
Is that Mud-Dauber nest mil-spec?
1992 Mercedes-Benz 250GD Wolf - Former German Army
St. Augustine, Florida
St. Augustine, Florida
-
- 2nd Lieutenant
- Posts: 877
- Joined: June 22nd, 2009, 2:29 pm
- Location: Taylorsville, UT
- Contact:
Re: M416 Wiring Question
It must be, mine came with one.mrdibbles wrote:Is that Mud-Dauber nest mil-spec?
1968 M151A1
1967 M416
1967 M416