Would someone please measure the distance between the choke and throttle cable knobs, center to center? I had to repair my dash where Bubba had put a gauge where the throttle used to be.....cut out a big ole hole!
Thanks,
Snuffy
Measurement needed
Moderators: rickf, raymond, Mr. Recovery
- Mr. Recovery
- Brigadier General
- Posts: 2901
- Joined: December 5th, 2007, 9:03 pm
- Location: New Port Richey, Fl.
- Contact:
Re: Measurement needed
snuffy, mine are 2&3/4" and are flat on the bottom.
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
-
- Colonel
- Posts: 1654
- Joined: November 26th, 2007, 7:44 am
- Location: ~Heaven~
Re: Measurement needed
I agree with Dan 2 3/4" between Choke & Throttle
The six holes to the right are for the 3 circuit breakers.
Horizontal distance is 1 1/2"
Vertical distance is 2"
I added this because I didn't know how big the hole in your dash was.
The six holes to the right are for the 3 circuit breakers.
Horizontal distance is 1 1/2"
Vertical distance is 2"
I added this because I didn't know how big the hole in your dash was.
Ralph
1967 M151A1
1967 M151A1
1967 M416
1947 Bantam TC-3 trailer
If The Phone Don't Ring ... You'll Know It's Me
Airborne Ranger CIB Vietnam
1967 M151A1
1967 M151A1
1967 M416
1947 Bantam TC-3 trailer
If The Phone Don't Ring ... You'll Know It's Me
Airborne Ranger CIB Vietnam
Re: Measurement needed
Thanks Dan & Ralph! Those pictures are great!
Mike
Mike