M416 Tail Lights problem
Moderators: rickf, raymond, Mr. Recovery
M416 Tail Lights problem
Ok. So I installed a new NOS wiring harness to my m416 and plugged it into my MUTT. The turn signals and brakes work fine with the jeeps headlights off but with the headlights on when you engage a turn signal both taillights blink at the same time and when you press the brakes the lights go out....Any Ideas?
Mike
196? M-151
1967 M-416
1942 Ford GPW
196? M-151
1967 M-416
1942 Ford GPW
Re: M416 Tail Lights problem
Bad ground, check the ground wire in the harness. Quick check is to hook a jumper cable to clean metal on the trailer and the other end of the cable to preferably the ground of the battery on the vehicle. See if all lights work now. If they do then the ground connection is bad somewhere in the line.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
Re: M416 Tail Lights problem
Thanks. I did not think of the ground being the issue. I will try that and see what happens....rickf wrote:Bad ground, check the ground wire in the harness. Quick check is to hook a jumper cable to clean metal on the trailer and the other end of the cable to preferably the ground of the battery on the vehicle. See if all lights work now. If they do then the ground connection is bad somewhere in the line.
Mike
196? M-151
1967 M-416
1942 Ford GPW
196? M-151
1967 M-416
1942 Ford GPW