Need front crossmember center repair panel

Got something you don't need? Sell it here

Moderators: rickf, raymond, Mr. Recovery

Post Reply
matt506
Corporal
Corporal
Posts: 35
Joined: August 2nd, 2009, 10:18 pm

Need front crossmember center repair panel

Unread post by matt506 » January 20th, 2018, 11:16 am

Does anyone have the center repair part for the front crossover that goes under the transmission? I bought all the parts minus this thinking it was good then the nasty rust poked it head out and it is peppered with rust holes. Even if I could get measurements to make one at work would be appreciated. Thanks Matt.

User avatar
Vzike
Sergeant Major of the "G"
Sergeant Major of the "G"
Posts: 729
Joined: December 27th, 2013, 4:05 pm
Location: Jupiter, Florida

Re: Need front crossmember center repair panel

Unread post by Vzike » January 20th, 2018, 11:41 am

If you are talking about just the one under the tranny mount, I have one I can measure out for you. Actually, I can trace it. Looks like an easy build. I have the full set that goes across to the sides, but I'd like to hang on to the three pieces.

Vin
914-850-0095

matt506
Corporal
Corporal
Posts: 35
Joined: August 2nd, 2009, 10:18 pm

Re: Need front crossmember center repair panel

Unread post by matt506 » January 21st, 2018, 2:22 pm

Vin great measurements would be great putting this under wanted and not for sale would be even better but…. yes this is a simple piece that if I got good measurements i could make it. I have the whole kit minus this part. Matt

User avatar
Vzike
Sergeant Major of the "G"
Sergeant Major of the "G"
Posts: 729
Joined: December 27th, 2013, 4:05 pm
Location: Jupiter, Florida

Re: Need front crossmember center repair panel

Unread post by Vzike » January 21st, 2018, 2:28 pm

Ok, Matt, better yet, I'll take my piece and make a template for you. Just PM your full mailing contact info, and I'll get it in the mail.

Vin

matt506
Corporal
Corporal
Posts: 35
Joined: August 2nd, 2009, 10:18 pm

Re: Need front crossmember center repair panel

Unread post by matt506 » January 21st, 2018, 6:11 pm

Vin you are the BEST! address as follows


Sent to Vin in a PM

Rick

User avatar
Vzike
Sergeant Major of the "G"
Sergeant Major of the "G"
Posts: 729
Joined: December 27th, 2013, 4:05 pm
Location: Jupiter, Florida

Re: Need front crossmember center repair panel

Unread post by Vzike » January 23rd, 2018, 12:54 pm

Hi Matt,

I took the part and traced a footprint template and outlined the profile. I don't have a way to flatten the part (nor would I) to make an actual pre-bend template. I also traced the locations of the weld holes. Please send me your email in a PM (avoid sending personal info on any open forum), and I'll send you a picture of what I have. If that looks like something you can work with, I'll fold it up and drop it in the mail.

Vin

Post Reply