Guys:
What is needed to replace the capacitor on a M151A1?
I have also read where it is called the "input" capacitor...Which is the correct name for this part?
Bubba got to my distributor, and modified the end of the capacitor, and I want to replace just that piece. There are four retaining screws, on the small square retention facing. I want to replace the part that the harness screws in - to. Is it as simple as removing those 4 screws, and replacing?
I have not yet taken it apart, and wanted to check in here first, before I dig in to the distributor and order the right parts that are needed.
Any advise is appreciated
Thanks!
Distributor Question and Help Needed
Moderators: rickf, raymond, Mr. Recovery
Distributor Question and Help Needed
1966 M151A1
Re: Distributor Question and Help Needed
Yup, it comes right off, also comes with the input (+) side wire from the coil.
Last 2Δ Command Group NCOIC
Re: Distributor Question and Help Needed
Bingo...That's what I needed...Perfecto - Thanks!
I am guessing the black wire attaches inside - Below the rotor? Just follow it in?
Is that part number, by chance, - 1394963 -, Is it printed on the part anywhere?
Thanks again!
I am guessing the black wire attaches inside - Below the rotor? Just follow it in?
Is that part number, by chance, - 1394963 -, Is it printed on the part anywhere?
Thanks again!
1966 M151A1