I noticed that there is a Pipe Plug in the bottom of the flywheel housing cover and it is shown in the TM. I assumed that it was to drain the flywheel housing but when I removed the cover screw I found the hole was sealed inside. Is this normal and am I wrong in thinking it is for drainage purposes?
Bill
Fltwheel housing
Moderators: rickf, raymond, Mr. Recovery
Re: Fltwheel housing
The plug is screwed into a blank for storage under normal conditions and it is screwed into the drain hole next to it for fording operation. It is covered in the manual.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
Re: Fltwheel housing
Rick,
Thanks for that. I crawled under the A2 again and you are right as usual.
Regards,
Bill
Thanks for that. I crawled under the A2 again and you are right as usual.
Regards,
Bill
Re: Fltwheel housing
The information on this site is always insightful. Thank you for keeping the site going.
Ted
1968 M151A1
1968 M151A1