bushing tool
Moderators: rickf, raymond, Mr. Recovery
bushing tool
Here is a A arm bushing install tool I threw together ,Could have ground torch cuts but I didn't .Works nice .No press to mess up the A arm. Read where a press will bend the arm.
You do not have the required permissions to view the files attached to this post.
Re: bushing tool
Nice! Is the hardware of sufficient strength to get that done? I would think that maybe a longer (deeper) nut would be in order for that process owing to the risk of stripping the threads.
-
- Brigadier General
- Posts: 2030
- Joined: February 19th, 2013, 11:38 pm
- Location: Mansfield, PA
- Contact:
Re: bushing tool
Nice idea. Anytime I use a press I always use a spacer to prevent damage to your point. I have one made up for doing the half shaft universals.
Guy
Guy
M151 Body Panels - http://www.m151bodypanels.com/
'68 A1 - Under full resto
'68 A1 - Under full resto