Hi all.....
About to install a NOS fording kit on my A2. NOT exactly sure how it goes, I have looked at a lot of pictures but could use some close up ones of both the front and rear mounting....or is there an instruction book or sheet?
Good close up pictures or instruction sheet would help.......Thank you all....BILL
Please reply back with any help at: NAM9TH@AOL.COM
Need help installing fording kit on A2
Moderators: rickf, raymond, Mr. Recovery
-
- Sergeant
- Posts: 92
- Joined: December 27th, 2012, 8:37 pm
-
- Staff Sergeant
- Posts: 170
- Joined: September 10th, 2009, 12:44 pm
Re: Need help installing fording kit on A2
if you start bolting some stuff up its kinda gonna fall in place as to where to drill holes ect.
Re: Need help installing fording kit on A2
The -34P manual has all the parts diagrams showing the positions of the parts in the Group 33 special purpose kits section figure 146. And in the -34 manual you will find the full instructions on installing the kit, again, in the special purpose kits section. I am not going to list a page since depending on the manual year it will be different but just look in the index.
On edit, I went back and looked at my -34 manuals and the early manual does not have the installation instructions, only the later one. Get it here.
g838_manuals/TM%209-2320-218-34-1%20aug1982.pdf
On edit, I went back and looked at my -34 manuals and the early manual does not have the installation instructions, only the later one. Get it here.
g838_manuals/TM%209-2320-218-34-1%20aug1982.pdf
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
Re: Need help installing fording kit on A2
There appears to have been an 8 page MWO-218-30-1 from 1961 for the deep water kit but I have not seen it. Most likely shows early version. Maybe online?
Also found a few pics here http://g838.org/viewtopic.php?f=12&t=27 ... ion#p23962
Also found a few pics here http://g838.org/viewtopic.php?f=12&t=27 ... ion#p23962
1960 M151 Run #1
"There is one nut on a M151 that is very difficult to remove....." - K8icu
"She ain't a Cadillac and she ain't a Rolls, But there ain't nothin' wrong with the radio" - Aaron Tippin
"There is one nut on a M151 that is very difficult to remove....." - K8icu
"She ain't a Cadillac and she ain't a Rolls, But there ain't nothin' wrong with the radio" - Aaron Tippin