What can I use for PL-S oil?

[09FordRanger]

Distributor is the last item on my lubricant list. As you folks probably know, it calls for PL-S oil. What is out there that I can buy that meets the specs?
Thanks for any suggestions.

[FoxMike]

https://www.g838.org/viewtopic.php?t=13464

[rickf]

3 in one oil is good, it is a fine grade machine oil and will soak into the wicks quite well. Motor oil will work also. You need a lubricant and not a solvent so keep that in mind.

[09FordRanger]

Thanks again Rick. I'm really pumped. I'm just finishing replacing quite a few new parts. The distributor lub is one of several final tasks for this summer. Still struggling with trying to tune my carb (I'm at 8500 feet so air/fuel mix is a bit off). But I have an ace in the hole. Friday I'm driving down to Fort Carson car care center. Rocky was an old Army 63B. We'll get it.

[rickf]

Find best idle with mixture screw then run the screw in 1/4 turn at a time and it should come in. If you are running ethanol gas that will will help it a hair since the alcohol will lean it out. You can change the main jet to a #28 but that will only help ate wide open throttle and even then it is questionable since the exhaust manifold prevents enough air flow to utilize the main.