Hi,
It's hard for me to find a wheel nut wrench for my A2. There's one in eBay for the A1.
Are the wheel nut diameters of A1 & A2 identical, so that I can use this tool ?
I would appreciate if somebody would let me know - thank you!
Greetings, Bernie (from Germany)
A1/A2 wheel nut wrench compatibility?
Moderators: rickf, raymond, Mr. Recovery
Re: A1/A2 wheel nut wrench compatibility?
I think the A2 wheel nuts are 1/2", the 151a1 is 7/16"? I have a 151 that is 7/16" I'll go out and measure them in a half hour or so
mark
1968 m274A5
1960 m151
1981 m151A2
1964 m416
1971 m416
1968 m274A5
1960 m151
1981 m151A2
1964 m416
1971 m416
Re: A1/A2 wheel nut wrench compatibility?
The A1 uses 11/16" wrench size and the A2 uses 3/4" wrench size. The correct tool for the A2 for the most part was a double ended tool with 11/16" on one end and 3/3" on the other. The A1 tool only had the 11/16" on one end.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
Re: A1/A2 wheel nut wrench compatibility?
I stand corrected big time, maybe dementia is creeping up me??
mark
1968 m274A5
1960 m151
1981 m151A2
1964 m416
1971 m416
1968 m274A5
1960 m151
1981 m151A2
1964 m416
1971 m416
Re: A1/A2 wheel nut wrench compatibility?
You had the wheel stud sizes mixed up with the lug nut sizes.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
Re: A1/A2 wheel nut wrench compatibility?
thank you for this information!
Greetings, Bernd
Greetings, Bernd