adding fuel to the carb
Moderators: rickf, raymond, Mr. Recovery
adding fuel to the carb
hello everyone.
I would like to ask if anyone knows why when I don't start my M151A2 for 3 weeks, it doesn't start unless I put a little gasoline directly into the carburetor.
With a syringe I inject a little of gasoline right in the inlet pipe, then engine turns on immediately
My carb is a zenith
I would like to ask if anyone knows why when I don't start my M151A2 for 3 weeks, it doesn't start unless I put a little gasoline directly into the carburetor.
With a syringe I inject a little of gasoline right in the inlet pipe, then engine turns on immediately
My carb is a zenith
Re: adding fuel to the carb
Are you pulling the choke all the way out when you try to start it? It will take a few cranks for it to pick up fuel. Once it fires once then push the choke in about halfway and hit the starter again and it should fire right up. No fuel injection here. And pumping the gas pedal will do no good since the accelerator pump is vacuum operated, if it is not running the pump will not work.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
-
- Brigadier General
- Posts: 2512
- Joined: October 1st, 2010, 12:19 am
- Location: El Dorado, Arkansas
Re: adding fuel to the carb
Pull your air cleaner hose, pull your choke lever out and make sure the butterfly is closing completely, needs to close all the way off.
Re: adding fuel to the carb
Hi, Thanks for the responses. I try to do it as Rickf says but the problem is that even if I do it that way it doesn't start.I try with more than 6/7 cranks but nothing happens.The problem only happens when it is stopped for more than 3 weeks. If I do it as you say and the engine starts every week it starts perfectly.
Tomorrow I will check what Hambone says
Tomorrow I will check what Hambone says
Re: adding fuel to the carb
this weekend, i'm following rickf's instructions exactly and the engine starts fine. Next three weeks i won't be able to use the aA2 and then i'll try it this way. i'll let you know. Thanks Rickf for the advice.
I Checked what, Hambone says Hanbone and it closes perfectly.thanks
Elmer
I Checked what, Hambone says Hanbone and it closes perfectly.thanks
Elmer
Re: adding fuel to the carb
Hi everybody,
This afternoon ,after 6 weeks without use my A2.I have started the engine following Rickf tips and the engine started perfectly.
I pulled the choke all the way out,I took two or three cranks then I pushed the choke in about Halfway or less , I hit the starter and everything was good.
Thanks Rickf
This afternoon ,after 6 weeks without use my A2.I have started the engine following Rickf tips and the engine started perfectly.
I pulled the choke all the way out,I took two or three cranks then I pushed the choke in about Halfway or less , I hit the starter and everything was good.
Thanks Rickf
Re: adding fuel to the carb
You just have to love a vehicle with no mechanical accelerator pump. pumping the gas pedal before starting does nothing on a vehicle with vacuum operated accelerator pump. So it is all choke.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone