Carburator Mod Project
Moderators: rickf, raymond, Mr. Recovery
Re: Carburator Mod Project
Every time he gets started on a project he finds a new girlfriend and the project sits. Then he starts another project and finds another girlfriend. If only he would get rid of at least one of the girlfriends he might get something done.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
- Mr. Recovery
- Brigadier General
- Posts: 2901
- Joined: December 5th, 2007, 9:03 pm
- Location: New Port Richey, Fl.
- Contact:
Re: Carburator Mod Project
HEY! I have a lot to do in the next 28 years.rickf wrote:Every time he gets started on a project he finds a new girlfriend and the project sits. Then he starts another project and finds another girlfriend. If only he would get rid of at least one of the girlfriends he might get something done.
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
Re: Carburator Mod Project
Better than my reasons for stalling on a project. I usually get bogged down by lack of funds or a busy work schedule. At least he is having more fun in his downtime between updates.
- Mr. Recovery
- Brigadier General
- Posts: 2901
- Joined: December 5th, 2007, 9:03 pm
- Location: New Port Richey, Fl.
- Contact:
Re: Carburator Mod Project
Today I installed the carburator mod power pack into my 67A1, here are some photos and a short video (if it works) I still need to make a air cleaner hook up and install a gas peddle cable. The video seems to be skipping, also keep in mind that the exhaust isn't hooked up.
power pack out.
power pack out.
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
Re: Carburator Mod Project
A bunji throttle, that is interesting. Not very precise though.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
- Mr. Recovery
- Brigadier General
- Posts: 2901
- Joined: December 5th, 2007, 9:03 pm
- Location: New Port Richey, Fl.
- Contact:
Re: Carburator Mod Project
Any Port in a storm! That was the first thing I could find that would reach around to the steering wheel area so I could sit on the gas tank and push the starter button, didn't need the choke. Did the video (1st small photo) work? My computer crashed again and I am on my sons.rickf wrote:A bunji throttle, that is interesting. Not very precise though.
Dan.
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
Re: Carburator Mod Project
Yes it was a little choppy but it worked. Stop downloading all of that "adult content" and you won't have as much problem with your computer.
And I can reach the carb with my left hand and push the starter button with my right with the door off. Must be the height differential.
And I can reach the carb with my left hand and push the starter button with my right with the door off. Must be the height differential.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
Re: Carburator Mod Project
While watching the video, there seemed to be a lag when the bungee cord was pulled and the throttle responded, similar to the regular Zenith carb setup. Although I understand this is a one-off modification in search of improvement, there didn't seem to be what I would consider a payoff for the large amount of work to date. Not being critical, just an observation. After all, it seems that there should be a side-draft carb setup that could be exploited for use on the M151 series other than one with an Ord number.....
Jim Peterson
SGM, 31B Retired 2015
1961 M151 -Sold
1974 M151A2, Working It!
SGM, 31B Retired 2015
1961 M151 -Sold
1974 M151A2, Working It!
-
- Sergeant
- Posts: 69
- Joined: April 6th, 2016, 9:28 am
Re: Carburator Mod Project
Any updates on this project? I am thinking about doing this kind of upgrade and was wandering how it was going. Also why did you go with the 32 DCOF and not a DCOE Carb?
CSM In the Texas State Guard
National United States Armed Forces Museum
1943 MB W/Trailer "Puddle Jumper II"
1968 m274A5 "Little S.N.A.F.U"
1976 M151a2 "Kermit"
National United States Armed Forces Museum
1943 MB W/Trailer "Puddle Jumper II"
1968 m274A5 "Little S.N.A.F.U"
1976 M151a2 "Kermit"
- Mr. Recovery
- Brigadier General
- Posts: 2901
- Joined: December 5th, 2007, 9:03 pm
- Location: New Port Richey, Fl.
- Contact:
Re: Carburator Mod Project
I used the DCOF because I wanted the manual choke, as I have sold the 67 and no longer have a driver there are no updates, it ran very good on the floor and sitting in the 67, was unable to get in any road time.
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
Re: Carburator Mod Project
Well Vin always has a dozen or so, just jog it across the state and pop it in one of his.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
- Mr. Recovery
- Brigadier General
- Posts: 2901
- Joined: December 5th, 2007, 9:03 pm
- Location: New Port Richey, Fl.
- Contact:
Re: Carburator Mod Project
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
Re: Carburator Mod Project
Hydraulic throttle
https://www.finditparts.com/products/20 ... fsQAvD_BwE
https://www.finditparts.com/products/20 ... fsQAvD_BwE
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
- Mr. Recovery
- Brigadier General
- Posts: 2901
- Joined: December 5th, 2007, 9:03 pm
- Location: New Port Richey, Fl.
- Contact:
Re: Carburator Mod Project
rickf wrote:Hydraulic throttle
https://www.finditparts.com/products/20 ... fsQAvD_BwE
Nice although a little pricey for my budget.
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's
Re: Carburator Mod Project
THAT's why you have a girl friend! Have HER pay for it then let her drive it.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone